Grabyo supports SRT (listener) and Zixi (pull) protocols for output (egress) workflows, such as taking streams from a broadcast facility, enhancing them in Producer and then sending them back using SRT or Zixi.

How to access Pro Outputs


  1. Select the content menu on a Producer stream

  2. Select OUTPUTS (LISTENERS)

  3. Select CREATE NEW LISTENER

  4. Input DISPLAY NAME

  5. Select the protocol type

  6. Input IP ALLOW LIST (OPTIONAL)

  7. Input ZIXI PULL REMOTE ID (not applicable for SRT)

  8. Input MINIMUM LATENCY (MILLISECONDS)

  9. Select ENCRYPTED OUTPUT (if applicable)

  10. Select SAVE LISTENER to finish


📕 Note: SRT / Zixi outputs are only supported for On-demand Producers.

Tip: Each listener that is created represents one potential SRT or Zixi output from the Grabyo platform (2 decoders cannot pull from the same listener at the same time), so you should create one listener for each simultaneous output you need. Each listener is independent and can have a different protocol and its own settings for latency and encryption.

Pulling content from a listener


  1. Select the content menu on a Producer stream

  2. Select OUTPUTS (LISTENERS)

  3. Select the listener of your choice and MORE INFO

  4. Find the LISTENER MANAGER VIEW INFO

  5. Once the listener stream is being pulled from status is CONNECTED


📕 Note: It’s not possible to edit an existing listener, however, you can create a new one so an existing one can easily be deleted and recreated with the new settings.

Tip: Here you can find more details on supported protocols within Grabyo Pro Ingest functionality.

Did this answer your question?